ESD separator with 3 mm PE foam, 553 x 353 x 6 mm, 3 bevelled corners - Warmbier 5425.0353.0553.PE

When assemblies are stacked on top of each other in a storage container, the upper layer presses on the one below. This separator, 553 x 353 x 6 mm, keeps the layers apart and combines two functions in one part, a stiff PP hollow chamber profile as the load-bearing plane and a glued-on 3 mm PE plug-in foam as the soft face.

Benefits

• Load-bearing profile side and cushioning foam side in one part, one layer goes in instead of two
• Profile side at 10^4 - 10^5 Ohm in the conductive range, foam side at 10^7 - 10^8 Ohm in the dissipative range
• Typical volume resistance of 10^7 Ohm, charge also drains through the separator itself
• 3 bevelled corners, the layer can be lifted out of a full container without a tool
• Overall height of only 6 mm, it costs almost no usable height inside the container

Application

Separating layer between stacked boards and assemblies in the storage container, top layer above the uppermost row, and bottom liner wherever a dissipative soft face is needed. The foam side faces the component, the profile side carries the next layer.