ESD soldering tip extraction kit with stainless steel tubes and silicone hose - Donaldson Bofa A1090026

A high-vacuum unit only performs once the extraction tube is firmly aligned on the iron and the hose follows the operator's movement. Kit A1090026 from Donaldson Bofa contains the complete ESD-safe parts needed to set up an extraction point at the soldering tip.

Benefits

• Three stainless steel extraction tubes in 6 mm x 220 mm, 6 mm x 110 mm and 5 mm x 200 mm for different iron shapes and working distances
• Four E-clips plus a rubber tube with iron holder for a firm alignment on the soldering iron
• 2.5 m of ESD silicone hose 6.5 x 4.5 mm included, so the point is ready to run
• Small brass brush to keep the tubes clear of flux residue
• ESD-safe design for use at electrostatic protected workstations

Applications

Setting up and retrofitting tip extraction points at hand soldering stations in electronics manufacturing, in repair and rework areas and in test laboratories. Also used as a spare set when tubes or hose have clogged with flux.

Compatibility and scope of delivery

Suitable for the Bofa high-vacuum extraction units TVT2, T1, T15, T30A, T60 and T100. Delivery comprises the three stainless steel tubes, four E-clips, one transparent plug, 2.5 m of silicone hose 6.5 x 4.5 mm, the brass brush and the rubber tube with iron holder.

The ESD-safe design supports operation at EPA workstations according to IEC 61340-5-1.