Farriers' pincers with small head and anvil for redirecting horseshoe nails, 300 mm - Knipex 55 00 300

When shoeing a horse, the nail has to be shortened and its end turned over cleanly without damaging the hoof wall. The 55 00 300 farriers' pincers are built for exactly that, the head of only 20.0 mm width reaches close to the hoof and the additionally hardened cutting edges of approx. 59 HRC sever the nail over a 20 mm edge length.

Benefits

• Small head of 20.0 mm width lets the pincers work close to the hoof.
• Anvil on the head for redirecting the ends of horseshoe nails.
• Cutting edges additionally hardened to approx. 59 HRC for a long service life.
• Cutting edge length of 20 mm covers the full nail cross section.
• 300 mm overall length at 780 g gives ample leverage for pulling tight nails.
• Also suitable for dismantling work in vehicle body workshops, so the tool earns its place twice.

Areas of use

Shoeing and hoof care in the forge and the stable, plus dismantling work in vehicle body shops such as tearing off sheet metal edges and rivets during repairs.

Standards and conformity

No product standard is stated in the manufacturer source. According to the manufacturer the pincers contain no substances of very high concern under REACH. The RoHS directive does not apply to this product.