Electronics diagonal cutter with carbide cutting edges, pointed head, 120 mm - Knipex 77 32 120 H

Where the wire sits between closely spaced components and is hard as well, you need both a pointed head and a durable edge. The 77 32 120 H electronics diagonal cutter combines a pointed head with chamfer and carbide cutting edges of 80 to 83 HRC.

Benefits

• Pointed head with chamfer and a small bevel reaches the wire even between closely spaced components.
• Precision carbide cutting edges soldered into forged blanks, edge hardness 80 to 83 HRC.
• For hard and tough materials such as piano, nickel, tungsten and diode wire in electronics and aerospace.
• Substantially longer service life than pliers with conventional edges, with no edge deformation under overload.
• Sturdy, through-going and backlash-free box joint guides the cut precisely.
• Capacity up to Ø 1.0 mm medium-hard, Ø 0.6 mm hard and Ø 0.2 mm piano wire, 120 mm long at 80 g.

Technical data

Areas of use

Electronics production, board repair and aerospace. The pointed head is what counts when cutting between components and close to the board.

Standards and conformity

The tool is built to DIN ISO 9654, the standard for electronics diagonal cutters. According to the manufacturer it contains no substances of very high concern under REACH, and the RoHS directive does not apply.