Pipe wrench 90° Swedish pattern, jaw capacity 42 mm, pipes up to 42 mm dia., 310 mm - Knipex 83 10 010

Threaded joints on pipework often sit tight and only give way to a wrench that locks itself as you pull. The 83 10 010 pipe wrench in Swedish pattern takes pipes up to 42 mm dia. and transmits the force over a 310 mm lever.

Benefits

• Jaws angled at 90°, so pipes close to a wall or in narrow ducts can still be gripped.
• Jaws with double offset teeth that bite in harder as the wrench is turned.
• Gripping jaws with specially hardened teeth, hardness approx. 56 HRC, teeth additionally induction hardened.
• Capacity of 42 mm for pipes up to 42 mm dia. and nuts up to 42 mm across flats, which corresponds to 1 inch inside diameter.
• I-beam handle design for high stiffness at 779 g.
• Captive adjusting nut, so the setting is not lost on site.

Areas of use

Plumbing and heating installation, pipework construction, agriculture and workshop. Wherever threaded pipes and fittings up to 42 mm dia. have to be tightened or released.

Standards and conformity

The wrench complies with DIN 5234 for Swedish pattern pipe wrenches. According to the manufacturer it contains no substances of very high concern under REACH, and the RoHS directive does not apply to this product.