Pipe wrench 90° Swedish pattern, jaw capacity 60 mm, pipes up to 60 mm dia., 420 mm - Knipex 83 10 015

On threaded pipe in heating and plumbing work, lever length decides whether a seized fitting comes loose. The 83 10 015 pipe wrench in Swedish pattern takes pipes up to 60 mm dia. and brings 420 mm of leverage to the job.

Benefits

• Jaws angled at 90°, so pipes close to a wall or in narrow ducts can still be gripped.
• Jaws with double offset teeth that bite in harder as the wrench is turned.
• Gripping jaws with specially hardened teeth, hardness approx. 56 HRC, teeth additionally induction hardened.
• Capacity of 60 mm for pipes up to 60 mm dia. and nuts up to 60 mm across flats, which corresponds to 1 1/2 inch inside diameter.
• I-beam handle design for high stiffness at 1415 g and 420 mm overall length.
• Captive adjusting nut, so the setting is not lost on site.

Areas of use

Plumbing and heating installation, pipework construction, agriculture and workshop. Wherever threaded pipes and fittings up to 60 mm dia. have to be tightened or released.

Standards and conformity

The wrench complies with DIN 5234 for Swedish pattern pipe wrenches. According to the manufacturer it contains no substances of very high concern under REACH, and the RoHS directive does not apply to this product.