Soldering station ALE-208VA 150 W with automatic solder feed Ø 0.8 mm and perforation - JBC ALE-208VA

Anyone making the same joint a hundred times loses time guiding the wire and loses quality through varying solder volumes. The ALE-208VA takes over both. It feeds Ø 0.8 mm solder wire at up to 55 mm/s and recovers the temperature within the 90 to 450 °C range after every contact using 150 W.

What the station delivers at production pace

• 150 W of heating power on one channel, so tip temperature stays inside the controlled 90 to 450 °C range even on ground planes and heavy traces.
• Automatic solder feed for Ø 0.8 mm wire at a feed speed of up to 55 mm/s, keeping the solder volume per joint repeatable.
• Solder wire perforation, so flux is released steadily during melting instead of in bursts.
• Three working modes. Continuous, alternating and a programming mode in which speed and length of the dispensed wire are set.
• Connectivity for data transfer, remote access for traceability and software updates.
• Takes solder wire spools up to 2 kg with a maximum height of 100 mm and diameter of 100 mm, so one spool lasts a long shift.

Applications

• Series soldering of repeating joints in electronics manufacturing
• Cable and connector assembly with a constant solder volume
• Workstations with traceability where process data is read out
• ESD protected areas following the workplace concept of the production line

ESD and design

The property table lists the station as ESD safe. It runs on 230 V and works with one channel.