Nano soldering and desoldering station 14 W per tool with NT115 handle and AN115 tweezers - JBC NASE-2D

A two terminal part in 0201 format only comes off when both pads are hot at the same time. The NASE-2D brings the adjustable AN115 nano tweezers for that job and the NT115 handle for soldering, both at 14 W on the C115 cartridge range.

Benefits in use

• The cartridge type decides compatibility. Both tools work exclusively with the C115 cartridge range.
• 14 W peak power per tool and a temperature range from 90 to 450 °C with ±3 % accuracy.
• Intelligent heat management with sleep and hibernation modes extends cartridge life fivefold.
• Resistance between tip and earth below 2 Ohm, voltage below 2 mV RMS, plus equipotential bonding to the EPA.
• A complete cleaning system with wiper and brush and the exclusive JBC cartridge changer are integrated.
• The JBC fume extraction connects over RJ12, USB-A carries firmware and profiles, USB-B goes to the PC, one pedal connection per tool.
• NT115 handle and adjustable AN115 nano tweezers are included, together with the HPTE0C9SA ESD tweezers.

Applications

Rework on the smallest SMD parts, removal of two terminal components with the heated tweezers, laboratory use and repair benches under the microscope where soldering and desoldering happen in one sequence.

Compatibility and scope of delivery

• NT115 nano handle for cartridges of the C115 range
• Adjustable AN115 nano desoldering tweezers for cartridges of the C115 range
• HPTE0C9SA high precision tweezers with ESD epoxy coating
• C115 cartridges are not part of the delivery

Standards and compliance

ESD-safe to ANSI/ESD S20.20 with equipotential bonding to the EPA, resistance between tip and earth below 2 Ohm. Operating voltage 230 V.