ESD flush cutter 114 mm with 30 degree angled tip, Pro Series - Weller LC665JN

On a tightly populated board a straight blade simply does not reach many leads. The LC665JN approaches at an angle of 30 degrees and cuts flush where a straight plier would sit on top of the parts.

Benefits in use

• Tip angled by 30 degrees for access between closely spaced components.
• Full flush cut, the lead is left without a protruding stub.
• Cutting length 6.4 mm at a head width of 12.7 mm and a head thickness of 7.5 mm, so the head stays slim.
• Listed as ESD safe by the manufacturer and suited to EPA workstations.
• Overall length 114.3 mm, Pro Series with blue handles.

Applications

Board rework, trimming component leads after soldering, repair work at ESD workstations.

Note

The manufacturer property table lists this tool as ESD safe.