Wristlab II tester for wrist strap and footwear without accessories - Iteco 9264960

This article is the bare measuring instrument of the Wristlab II range, without footplate, instruction panel or stand. It is the right choice as a replacement unit for an existing test station, or when footplate and panel are already in place and only the electronics are exchanged.

Key features

• Wrist strap and footwear tested to IEC 61340-5-1 with a clear pass or fail result
• Left and right shoe measured separately instead of a combined reading over both feet
• Test voltage of 50 V or 100 V for high resistance soles
• Wrist strap window 750 kΩ to 35 MΩ, footwear upper limit selectable from 10 MΩ to 200 MΩ
• Relay contact for releasing the EPA access, for example at a turnstile
• Compact housing of 156 x 110 x 34 mm and 340 g, powered by a 9 V battery or 9 V DC

Four operating modes

• Simultaneous measurement of wrist strap and footwear in a single test
• Wrist strap only, for operators seated at the workstation
• Footwear only, for visitors without a wrist strap
• HandsFree: if both shoes pass the series measurement, the internal relay switches and releases the access gate to the EPA

Applications

As a replacement or second unit for test points at the EPA entrance and in test laboratories where personnel grounding is checked on a sample basis.

Matching articles

Footplate 9264.965, instruction panel 9264.962 and stand-up column 9264.953 complete the instrument into a full test station. Ready made combinations are the wall station 9264.950 and the stand-up station 9264.952. Recalibration is covered by 9264.955.

Made in Italy by Iteco, with an ISO 9000 traceable calibration report.