Cable shears with twin cutting edge for cable up to Ø 20 mm, comfort handles, 200 mm - Knipex 95 12 200 SB

A cable of Ø 20 mm is too much for an ordinary shear of the same size, and the cut turns into a test of strength. The 95 12 200 SB cable shears therefore split the job: the front part of the cutting edge pre-cuts the insulating sheath and the rear part parts the conductor, so copper and aluminium cable up to Ø 20 mm, that is up to 70 mm², can be cut with one hand. This version comes on a self-service card in a blister pack.

Advantages

• Cuts copper and aluminium cable up to Ø 20 mm (70 mm²) cleanly, without crushing the conductor.
• Twin cutting edge with a pre-cut for the insulating sheath and a final cut for the conductor, so the full diameter can be cut single-handed.
• Low effort thanks to favourable leverage ratios and a special cutting edge geometry.
• Hardened cutting edges with a precision grind for a long service life of the cutting edge.
• Adjustable screwed joint, self-locking, the cutting clearance stays adjustable over the tool life.
• A pinch guard prevents crushed fingers, and the three-component comfort handles offer two KNIPEXtend interfaces.

Areas of use

Electrical installation, control cabinet and plant construction, power supply and assembly work. The twin cutting edge pays off wherever cable of larger diameter up to 70 mm² is cut to length on a regular basis.