Slotted Wall 400 for RS 180 Rack System, 355 x 32 x 180 mm, without Base Stop

The slotted wall is the part that does the actual work in a rack. Its grooves take each board individually and hold it upright. This version for width 400 measures 355 x 32 x 180 mm, weighs 0,48 kg and comes non-reinforced and without a base stop, which suits loads where the board needs no extra stop at the bottom.

Benefits

• Outer size 355 x 32 x 180 mm: the size 400 build of the RS 180 rack system, matched to the profile rails of the same range.
• One board per slot: every board stands on its own, neighbouring assemblies do not touch and do not rub against each other in transit.
• Without base stop: the slot stays clear over its full depth, so boards carrying components along the bottom edge can be pushed all the way in.
• 0,48 kg of its own: even a pair of walls plus rails stays light enough to move the container by hand.
• Modular: two slotted walls plus profile rails make a rack, and the range also carries the version with a base stop.

Applications

Two of these walls plus profile rails form the fixture in which populated boards wait between SMT, test and final assembly, or travel across the plant. Standing boards on edge is the usual approach inside the EPA because the board is only guided along its edge and the populated side stays clear.