ESD extraction arm DN100, 3 joints, 1370 mm, ATEX, black, wall mounting - Alsident 100-6555-2-6

Where solvents are used and there is a risk of explosion, the capture device must not become an ignition source through static charge. The Alsident 100-6555-2-6 is a System 100 AS extraction arm with 1370 mm reach, 3 joints and a Ø 100 mm tube for wall mounting, designed for airflows of 140 to 400 m³/h.

Benefits

• 1370 mm reach with 3 joints, self-supporting design with threaded rods and springs inside the arm
• Designed for 140 to 400 m³/h, suited to larger volumes of vapour or dust
• Tubes and joints in black conductive polypropylene, approved for ESD and Ex areas to EN 80079-36:2016 and EN 80079-37:2016, marked Ex II 1 GD
• Threaded rods, springs and finger screws in acid-resistant AISI 316L stainless steel, maintenance-free O-rings
• Dismantled and reassembled without tools, maintenance is limited to cleaning as needed

Specifications

Applications

• Explosion hazard areas (ATEX) where solvents are handled
• Laboratories and industrial areas with special requirements for charge dissipation
• ATEX areas, where the manufacturer recommends spark-free brackets in acid-resistant stainless steel (EN 1127-1 clause 5.3)

Compatibility and scope of delivery

• System 100 AS hoods: 1-10024-6 (Ø 200), 1-10035-6 (Ø 385), 1-10050-6 (Ø 500) and 1-1004228-6 (420 x 280), ordered separately
• Wall bracket 2-100-203-22-6 in acid-resistant AISI 316L stainless steel with black top, ordered separately
• Reducing sleeve 4-100125-6 (Ø 100 to 125 mm) and protective grid 5-18-6 available as accessories
• Supplied with a fixed earth lead for Ex areas and a separate earth lead with 1 MΩ resistor for ESD areas