ESD Safety Low Shoe GX 95 Women S3, Microfibre, Anthracite Black - Atlas 16100

Where swarf and wire offcuts lie on the shop floor, S2 is no longer enough. The GX 95 is the puncture resistant version of the women's model from the ATLAS WOMEN series and closes that gap without the wearer having to fall back on a men's last.

What sets this shoe apart

• Dissipative to DIN EN 61340-5-1: the shoe drains the wearer's static charge through the sole instead of carrying it to the next component. This is the basic requirement for an EPA to work at all.
• The last comes from the ATLAS WOMEN series and is calculated for the proportions of a woman's foot, with a narrower heel and a lower instep. A scaled down men's shoe never sits right at exactly those two points.
• Steel toe cap to EN ISO 20345:2012, tested at a minimum of 200 joules impact energy and 15 kN compression. The cap is anatomically shaped and does not press on the toes.
• Puncture resistant without metal: the XP midsole made of aramid fabric stops nails and swarf, weighs less than a steel midsole and leaves the foot its natural torsion. Metal-free also means the shoe does not trigger metal detection.
• SPORTY LIGHT sole system with MPU REBOUND SYSTEM. A pressure relieving insole and light MPU foam absorb the impact and return it into the push off, so the shoe feels more like a sports shoe.
• Water repellent microfibre upper, air permeable, quick drying and hard wearing. Together with the clima-stream concept of breathable upper, thermoregulating lining and Klima Komfort insole, the foot climate stays bearable even on a summer shift.
• The aktiv-X functional lining actively regulates moisture, does not stain and is abrasion resistant. After the shift the shoe dries through quickly.
• Approved for orthopaedic insoles per DGUV rule 112-191. Anyone who wears an insole does not have to fall back on a safety shoe without approval.

Areas of use

• Electronics manufacturing and EPA areas to DIN EN 61340-5-1
• Assembly and inspection stations close to cleanrooms
• Light assembly and laboratory work
• Indoor warehouse and order picking

Standards and conformity

• EN ISO 20345:2012, protection class S3 with slip resistant outsole SRC. S3 means a closed heel area, antistatic properties, an energy absorbing heel, water repellent upper, a puncture resistant sole and a cleated outsole.
• DIN EN 61340-5-1 for the ESD workplace. The shoe is the dissipative link in the chain of person, shoe and floor.
• PPE Regulation (EU) 2016/425, risk category II.
• DGUV rule 112-191 for orthopaedic insoles.

Sizes

The article covers sizes 35 to 43, every size in the standard width 10. The required size is selected when ordering.