ESD Safety Low Shoe FLASH 5400 S2, SportLine upper, width 12, black/blue - Atlas 19812

Part of a workforce never gets through a shift in standard width without pain, and then the safety shoe comes off instead of staying on. The FLASH 5400 ESD in width 12 solves that without cutting protection, because class S2, ESD equipment and the MPU INNOFLEX sole system are identical to the standard version.

What this model delivers

• Width 12 instead of an exemption. Width 12 runs considerably wider than the standard width 10 and takes pressure off the ball of the foot and the toe joint. The same model is also available in widths 10, 13 and 14.
• The charge goes into the floor, not into the assembly. The ESD equipment makes the shoe part of the EPA to DIN EN 61340-5-1. On a dissipative floor the wearer charge drains continuously instead of building up until someone reaches for a board.
• alu-tec cap, noticeably lighter than steel. The anatomically shaped aluminium toe cap shifts the centre of gravity towards the middle of the foot and helps prevent trips caused by imbalance. Aluminium is thermally neutral, so no cold bridge forms inside the shoe. EN ISO 20345 requires every toe cap to hold 200 joules impact energy and 15 kN compression.
• S2 in plain words. Closed heel area, antistatic construction, energy absorbing heel and a water repellent upper. Penetration resistance is not part of S2, which keeps the shoe light.
• MPU INNOFLEX outsole system. The INNOFLEX LINE guides forces from heel to toe, the CLOUDZONE in the heel absorbs impact, the DYNAMIC PLATES in the forefoot transfer forward energy. Slip resistance SR.
• SportLine upper. The textile fabric is air permeable and breathable, and its hydrophobic finish also makes it water repellent, quick drying and hard wearing. The aktiv-X functional lining regulates moisture inside the shoe.
• Cushioning and insoles. The 3D cushioning system combines a pressure relieving insole with a responsive MPU midsole. The abrasion resistant MPU toe guard extends service life during kneeling work, and the model is approved for orthopaedic insole fitting under DGUV rule 112-191.

Technical data

Applications

Electronics manufacturing and PCB assembly, test and repair benches, mechanical assembly and final inspection, goods receipt, warehouse and order picking with long walking distances, and office staff who enter the shop floor.

Standards and conformity

• EN ISO 20345:2022, safety footwear for professional use, protection class S2 SR. The manufacturer lists the article under this edition.
• Aluminium toe cap, EN ISO 20345 requirement of 200 joules impact energy and 15 kN compression
• Slip resistance SR
• ESD equipment for workplaces to DIN EN 61340-5-1. EN ISO 20345 itself only verifies the antistatic range, the ESD proof belongs to the workplace concept.
• PPE Regulation (EU) 2016/425, risk category II
• Suitable for orthopaedic insole fitting under DGUV rule 112-191
• Manufacturer ATLAS-Schuhfabrik GmbH & Co. KG, Dortmund

Sizes and delivery

Available in EU sizes 36 to 49 in width 12. Supplied as one pair.