Replacement blade for FT-45 crimp tool, set with spacer and screw - IDEAL 30-4951

The cutter of the FT-45 trims the fed-through conductors flush with the face of the plug on every crimp and wears down over time. This replacement blade keeps the tool in service instead of replacing it: blade, spacer and screw come as a complete set and are fitted with a Phillips screwdriver.

Benefits

• Genuine IDEAL spare part for the FT-45 crimp tool (30-495)
• Complete set of blade, spacer and screw, no small parts to source separately
• No special tooling required, a Phillips screwdriver is enough
• Rated by the manufacturer for more than 2000 cuts
• Restores the flush cut and with it the quality of the termination

Applications

• Maintenance of the FT-45 crimp tool in network and structured cabling
• Service and installation vans where plugs are terminated every day
• Workshop and control cabinet building with a high throughput of RJ-45 plugs

Usage notes

• Replace the blade when the conductors are no longer trimmed cleanly and flush.
• The manufacturer recommends replacement after approximately 2000 terminations.
• Release the tool, undo the screw, take out blade and spacer and fit the new set in the same orientation.