Crimping pliers for wire ferrules 0.25 - 16.0 mm², nine dies, comfort handles, 180 mm - Knipex 97 72 180

When making off stranded conductors, the crimp decides whether sleeve and conductor keep contact for good. The 97 72 180 crimping pliers press wire ferrules to DIN 46228 parts 1 + 4 from 0.25 to 16 mm² in nine marked half-round dies and weigh only 242 g.

Benefits

• Nine particularly deep dies with conical side faces cover the full range of 0.25 - 16.0 mm², which is AWG 24 - 6.
• Crimping in marked half-round dies gives a reliable connection between sleeve and conductor, and the right die is found without searching.
• Light and slim design, 242 g at 180 mm overall length, easy to handle even in a crowded control cabinet.
• Optimised transmission ratio keeps crimping easy and spares the hand over many connections.
• Comfort handles made of three ergonomic components with two KNIPEXtend interfaces for extensions.
• The same range is available as a VDE version where insulated work is required.

Areas of use

Electrical installation, control cabinet and plant construction, service and maintenance. Wherever fine-stranded conductors are fitted with ferrules before they go into a terminal, from a 0.25 mm² control cable to a 16 mm² supply line.

Standards and conformity

The pliers crimp wire ferrules according to DIN 46228 parts 1 + 4. According to the manufacturer they contain no substances of very high concern under REACH. The RoHS directive does not apply to this product.