Solder cartridge tip chisel 5 x 11.4 mm 302 °C STTC series - Metcal STTC-565

For hand soldering of pads and leads that need heat quickly, the STTC-565 cartridge from the Metcal STTC series provides a chisel tip of 5 x 11.4 mm at a fixed working temperature of 302 °C. The heater sits inside the cartridge itself and the temperature is maintained inductively, so neither calibration nor readjustment is needed.

Benefits

• Self regulating tip temperature of 302 °C without calibration or controller setting
• Chisel face 5 mm wide transfers heat over a large area to pad and component lead
• Tip length 11.4 mm for access to joints on densely populated assemblies
• Cartridge change in seconds with the MX-H1-AVA and MX-RM3E hand pieces

Technical data

Applications

The cartridge is used at hand soldering benches in electronics production, repair and prototype work. The wide chisel face suits ground planes, connector pins, shielding cans and stranded wire joints with a high heat demand. The low tip temperature limits heat input into sensitive components and board material.

Compatibility and scope of delivery

The STTC-565 cartridge fits the MX-H1-AVA and MX-RM3E hand pieces and runs on the Metcal MX-500, MX-5000 and MX-5200 systems. Within the STTC series tip geometry and working temperature can be combined freely while the hand piece stays the same. Scope of delivery is one STTC-565 solder cartridge tip, order unit piece.