ESD precision electronics diagonal cutter mini head, edges 64 HRC, 120 mm - Knipex 79 02 120 ESD

In an ESD protected area a tool must not carry charge onto the assembly and still has to reach close to the component. The 79 02 120 ESD precision electronics diagonal cutter has electrically dissipative handles, a mini head 9 mm wide and cuts hard wire up to 0.6 mm dia. with induction hardened edges of approx. 64 HRC.

Benefits

• Handles electrically dissipative to DIN EN 61 340-5 for use in electrostatic protected areas.
• Very accurately ground, sharp cutting edges for exact cuts on sensitive electronic components, soft wire from 0.2 to 1.4 mm dia.
• Precision edges additionally induction hardened, cutting edge hardness approx. 64 HRC, medium hard wire up to 1.0 mm dia.
• Mini head with 9 mm head width and 6.5 mm jaw length, with a very small bevel, for access between closely spaced components.
• Bolted joint with particularly carefully machined joint faces for an even, low-friction movement over the whole opening range.
• Approx. 20 % lighter than conventional electronics pliers at 57 g, plus a smooth-running double spring for gentle opening.

Areas of use

The finest cutting work in electronics and precision mechanics, board assembly and repair in ESD protected workplaces, laboratory work and prototyping. The mini head is particularly suited to cuts between closely spaced components.

Standards and conformity

The cutter complies with DIN ISO 9654 and DIN EN 61 340-5. According to the manufacturer it contains no substances of very high concern under REACH. The RoHS directive does not apply to this product.