M12 connection cable 8-pin 3 m for series 200.1 - ULT 03.1.300

The extraction and filter units of the ULT 200.1 series carry an 8-pin M12 socket on the rear. Through it the unit reports operation and filter load to a controller and can be switched remotely from there. This pre-assembled connection cable provides that link with a 3 m lead, with no connector work on site.

Benefits

• Mating part for the 8-pin M12 socket of the 200.1 series, where this interface is standard equipment
• 3 m lead assembled at the factory, no wiring work at the workstation
• Carries the operation message and the signals particulate filter nearly saturated and particulate filter saturated to the plant control
• Remote control input for start and stop from the machine, standby operation shows white on the LED status ring
• Screwed M12 connection, so the plug connection on the mobile unit does not drop out under vibration

Pin assignment of the M12 interface

The signals on contacts 2 to 4 are only valid while the unit is connected to supply voltage and the main switch is on. Inputs 5 and 6 can be triggered from the 12 V output on contact 7 or with an external voltage up to 24 V whose ground is then connected to contact 8.

Applications

Integration of a 200.1 series extraction and filter unit into a machine or plant control, for example starting extraction together with the laser or the soldering line and passing the filter load signal on to the control room.

Compatibility and scope of delivery

For extraction and filter units of the ULT 200.1 series, for example ACD 200.1, ASD 200.1, LAS 200.1 and LRA 200.1. Supplied as one pre-assembled cable of 3 m length.