Four-mandrel crimping pliers for turned contacts 0.14 - 6 mm² with contact holder, in a case, 230 mm - Knipex 97 52 65

A turned socket contact is only crimped reliably when all four mandrels advance at the same time and by the right amount. The 97 52 65 four-mandrel crimping pliers feed the mandrels synchronously and are set on the adjusting wheel in steps of 0.01 mm for cross-sections from 0.14 to 6 mm².

Benefits

• Synchronised feed of the four crimping mandrels for an even compression all around the contact.
• Mandrel feed adjustable in steps of 0.01 mm on the adjusting wheel, so every conductor cross-section from 0.14 to 6 mm² can be matched.
• Trigger lock according to IEC 60352 as a positive lock, the pliers open only after a completed crimping stroke and can be unlocked if required.
• Mounted exchangeable contact holder with locator, suitable for turned pin and socket contacts from common manufacturers.
• Basic setting can be checked with the enclosed test gauge, a table gives the required settings.
• Range of applications extendable by exchanging the contact holders, so the tool stays usable when contact systems change.

Areas of use

Connector assembly in control cabinet and machine building, maintenance and test departments. Intended for turned contacts from Harting, Ilme, Phoenix Contact, TE Connectivity, Amphenol, Walther and Weidmüller. The pliers are supplied in a plastic case with a foam insert.

Standards and conformity

The trigger lock complies with IEC 60352. According to the manufacturer the product contains substances of very high concern under REACH, the RoHS directive does not apply.