Diagonal cutter for electromechanics, lap joint, 63 HRC cutting edges, 125 mm - Knipex 76 01 125

On terminal strips and assemblies the cut has to be right first time, without the tool slipping. The 76 01 125 diagonal cutter for electromechanics works with sharp, precisely aligned cutting edges of approx. 63 HRC and cuts soft wire from 0.4 to 3 mm.

Benefits

• Sharp, precisely aligned cutting edges cut even fine cores cleanly and without a burr.
• Cutting edges additionally induction-hardened to approx. 63 HRC, hard wire up to 1.5 mm.
• The lap joint keeps the jaws in line and gives a consistently accurate closure.
• Compact head geometry with a head width of 14.5 mm and a jaw length of 16 mm, well suited to crowded assemblies.
• 125 mm overall length at only 85 g, plastic coated handles, manufactured to DIN ISO 5749.

Areas of use

Electromechanics, control cabinet and equipment construction, repair of assemblies and wiring harnesses, and all fine work where cores are cut close to the component.

Standards and conformity

The tool is made to DIN ISO 5749. It is not insulated and therefore not intended for live working. According to the manufacturer it contains no substances of very high concern under REACH, the RoHS directive does not apply.