Diagonal cutter for electromechanics, 63 HRC cutting edges, chrome-plated, 125 mm - Knipex 76 05 125

When making up wiring and working on populated assemblies, wires have to be cut flush without touching neighbouring parts. This diagonal cutter uses induction-hardened cutting edges of approx. 63 HRC to cut hard wire up to 1.5 mm and piano wire up to 0.6 mm in diameter.

Benefits

• Cutting edge hardness of approx. 63 HRC through additional induction hardening, giving a long service life even on hard wire.
• Sharp, precisely aligned cutting edges cut soft wire from 0.4 to 3 mm diameter cleanly.
• Slim head with 14.5 mm head width and 16 mm jaw length reaches densely packed areas.
• Lap joint guides the cutting edges with little play and keeps them aligned.
• Comfort handles made of three ergonomic components, with two KNIPEXtend interfaces for extensions.
• 125 mm overall length at 118 g, which spares the hand across a full shift.

Technical data

Applications

Electromechanics and control cabinet building, making up wiring and cable harnesses, precision engineering, model and prototype construction as well as service and repair on assemblies.

Standards and compliance

The diagonal cutter complies with DIN ISO 5749. It contains no substances of very high concern as defined by the REACH regulation, and the RoHS directive does not apply to this hand tool.