Diagonal cutter for electromechanics, hard wire up to 0.8 mm, slim, 125 mm - Knipex 76 81 125

On densely populated assemblies every millimetre of head height counts. The 76 81 125 diagonal cutter is only 12 mm high, weighs 85 g and cuts medium-hard wire up to Ø 1.3 mm and hard wire up to Ø 0.8 mm.

Benefits

• The flat 12 mm head reaches the wire even between closely spaced components.
• Sharp, precisely closing cutting edges, additionally induction-hardened to approx. 63 HRC.
• Capacity up to Ø 1.3 mm medium-hard, Ø 0.8 mm hard and Ø 0.4 to 1.7 mm soft wire.
• Lap joint for accurate jaw guidance with little play.
• Plastic-coated handles, black atramentised body with polished head.
• Only 85 g at 125 mm length, suited to fine work over longer periods.

Areas of use

Precision engineering, electromechanics and repair work on populated assemblies where the cut has to sit close to the board or the component.

Standards and conformity

The cutter is built to DIN ISO 5749, the standard for diagonal cutting nippers. According to the manufacturer it contains no substances of very high concern under REACH, and the RoHS directive does not apply.