Diagonal cutter for electromechanics, multi-component grips, 63 HRC, 125 mm - Knipex 76 12 125

Anyone shortening wire all day feels the difference between a hard shell and a multi-component grip. The 76 12 125 diagonal cutter combines those handles with induction-hardened edges of about 63 HRC that cut medium-hard wire up to Ø 2.3 mm.

Benefits

• Multi-component grips sit softly in the hand and hold even with damp fingers.
• Sharp, precisely closing cutting edges separate thin wires cleanly.
• Cutting edges additionally induction-hardened to approx. 63 HRC.
• Capacity up to Ø 2.3 mm medium-hard, Ø 1.5 mm hard and Ø 0.6 mm piano wire.
• The lap joint guides the jaws accurately, the head is polished and the pliers are black atramentised.
• Length 125 mm at 112 g, handy for work directly on the component.

Areas of use

Electromechanics, device assembly, installation and service work on modules. The soft grips pay off when many cuts follow one another.

Standards and conformity

The cutter is built to DIN ISO 5749, the standard for diagonal cutting nippers. According to the manufacturer it contains no substances of very high concern under REACH, and the RoHS directive does not apply.