Diagonal cutter for electromechanics, chrome-plated, 63 HRC cutting edges, 125 mm - Knipex 76 03 125

When shortening connecting wires on a device the cut has to be right the first time. The 76 03 125 diagonal cutter separates medium-hard wire up to Ø 2.3 mm and hard wire up to Ø 1.5 mm, its edges being additionally induction-hardened to about 63 HRC.

Benefits

• Sharp, precisely closing cutting edges separate even thin wires cleanly instead of crushing them.
• Cutting edges additionally induction-hardened to approx. 63 HRC, so they stay sharp over many cuts.
• The lap joint guides the jaws accurately and keeps play low.
• Capacity up to Ø 2.3 mm medium-hard, Ø 1.5 mm hard and Ø 0.6 mm piano wire covers the usual wire grades.
• Pliers and head are chrome-plated, which protects the surface against corrosion.
• Compact 125 mm at only 85 g, easy to guide through long stretches of work.

Technical data

Areas of use

Electromechanics, device assembly, control cabinet work and test benches. Wherever connecting wires and thin strands have to be cut close to the component.

Standards and conformity

The cutter is built to DIN ISO 5749, the standard for diagonal cutting nippers. According to the manufacturer it contains no substances of very high concern under REACH, and the RoHS directive does not apply.