Electricians' shears angled with crimping areas 0.5 - 6 mm² and 10 - 25 mm², 180 mm, blister card - Knipex 95 05 20 SB

When making up connecting cables, cutting and crimping alternate every few minutes. The angled 95 05 20 SB electricians' shears cut flexible and stranded cables up to 15 mm dia. and crimp wire ferrules from 0.5 - 6 mm² as well as from 10 - 25 mm², with stainless steel blades reaching 56 HRC.

Benefits

• Two crimping areas for wire ferrules from 0.5 - 6 mm² and 10 - 25 mm², so a separate crimping tool is not needed for the usual cross sections.
• Precision-ground blades with fine serrations for a clean, non-slip cut even on soft insulation.
• Adapted to the human hand, angled blades and an optimised handle design improve ergonomics when working overhead and inside control cabinets.
• Suitable for 1 x 25 mm² rubber connecting and control cable, 5 x 2.5 mm² heavy rubber hose line and 5 x 1.5 mm² damp-proof installation cable.
• Opening spring for low-fatigue work, lockable for transport.
• Tether attachment point for a fall arrest lanyard, so the shears can be secured when working at height.

Areas of use

Electrical installation, control cabinet building, service and assembly. The shears are not suitable for solid conductors. The matching belt pouch 00 19 75 LE is available separately.

Standards and conformity

According to the manufacturer the shears contain no substances of very high concern under REACH, and the RoHS directive does not apply to this product. The SB suffix denotes the self-service blister card packaging, the tool itself corresponds to the 95 05 20 version.