Support wheel for automatic solder wire feeder SFR-B, wire 1.2 to 1.6 mm - JBC 0019481

Inside the SFR-B feed the support wheel presses the solder wire against the drive wheel. If its groove does not match the wire gauge the feed slips and the solder volume per joint drifts. This wheel covers the range from 1.2 to 1.6 mm.

Key benefits

• Groove profile for wire from 1.2 to 1.6 mm, so the drive wheel grips over the full contact length.
• Listed as ESD safe by the manufacturer, which suits it to workstations with ESD protective measures.
• Original part of the SFR-B model line, shaft dimension and groove geometry match the series build.
• Orderable individually as a wear part, the swap restores the original feed without further adjustment.

Applications

Automated soldering with heavier wire, for example on power components, ground planes and larger joints where 1.2 to 1.6 mm wire is run.

Compatibility and scope of delivery

For the SFR-B automatic solder wire feeder, wire range 1.2 to 1.6 mm. One piece is supplied.

Standards and compliance

ESD safe according to the manufacturer data sheet. Manufacturer is JBC Soldering SL in Spain.