ESD safety shoe SL 82 blue 2.0 S1, SportLine fabric, width 10, black/royal blue - Atlas 44900

Anyone standing at a test bench or on a module assembly line needs no boot but a light shoe that drains the static charge reliably. The SL 82 blue 2.0 is ESD compliant and rated protection class S1 to EN ISO 20345:2022. It combines an air-permeable SportLine fabric with the alu-tec aluminium cap for 200 joules of impact energy and 15 kN of compression, plus an abrasion-resistant MPU toe bumper. It ships in standard width 10 and sizes 36 to 49.

What sets this model apart

• Dissipate the charge, do not collect it. The shoe is ESD compliant. Measured by the person-shoe-floor method of DIN EN 61340-5-1, the resistance stays below 100 MOhm, so the wearer charge drains to ground in a controlled way. In practice that means no component fails from a discharge on the walk between bench and machine. The plain antistatic requirement of EN ISO 20345, 100 kOhm to 1000 MOhm, does not cover this. It protects the person, not the electronics.
• S1 in plain words. A closed heel area, antistatic construction and a heel region that absorbs impact energy, plus the toe cap that every protection class of EN ISO 20345 requires. For dry indoor areas such as production, test benches and stores, that is the right level of equipment.
• alu-tec aluminium cap instead of steel. It passes the same test of 200 joules impact energy and 15 kN compression to EN ISO 20345, yet weighs less and shifts the centre of gravity towards the middle of the foot. That helps prevent trips caused by imbalance. Aluminium behaves thermally neutral and forms no cold bridge into the shoe.
• SportLine fabric for lasting breathability. The upper is built from textile fibres and is notably air-permeable. It weighs less than leather, stays breathable and follows every movement of the foot without pressing at the ball or the instep.
• INNOFLEX outsole with MPU tread zones. The sole complex guides the force along the INNOFLEX LINE from heel to toe. The CLOUDZONE in the heel absorbs the energy and the large MPU tread zones return it into the next step. The 3D cushioning system adds a pressure-relieving insole to the responsive MPU sole. Anyone spending eight hours on a concrete floor notices the difference by the evening.
• clima-stream concept for the foot climate. A breathable upper, the moisture-regulating aktiv-X functional lining and the Klima Komfort insole work as one system. The lining does not bleed colour, is skin-friendly and abrasion-resistant, and the shoe dries through quickly after the shift.

Technical data

Areas of use

Electronics manufacturing and module assembly, test and measurement benches, service workshop, order picking and stores inside the EPA. The textile fabric plays to its strengths in heated halls where leather shoes get warm. In wet areas or outdoors, a model in class S2 or S3 is preferable.

Standards and conformity

• EN ISO 20345:2022, protection class S1
• Slip resistance SR to EN ISO 20345:2022
• ESD compliant to DIN EN 61340-5-1, person-shoe-floor resistance below 100 MOhm
• Antistatic construction to EN ISO 20345, resistance between 100 kOhm and 1000 MOhm
• PPE Regulation (EU) 2016/425, risk category II
• Orthopaedic insoles to DGUV rule 112-191

Sizes

Available in sizes 36 to 49 in standard width 10. The sales unit is one pair. This listing covers the full size range, the size is chosen at ordering. The model is approved for orthopaedic insoles to DGUV rule 112-191, the marking inside the shoe is decisive.