2-Layer ESD Rubber Mat Roll, 15.2 m, 2 mm, 0.61 to 1.22 m Wide, Choice of Colour - Desco

This two-layer ESD rubber mat is made for stations where soldering and repair take place: heat and chemical resistant, with a dissipative top layer (1 x 10⁶ to < 1 x 10⁹ ohms Rtt) and a conductive black bottom layer. Available as full rolls 15.2 m long, with size and colour chosen in the variant selector.

Key benefits

• Dissipative top layer at 1 x 10⁶ to < 1 x 10⁹ ohms Rtt drains charges in a controlled way, without a sudden discharge into the part.
• Conductive black bottom layer spreads the charge across the whole surface to the ground point, Rtg below 1 x 10⁹ ohms.
• Heat, solder-iron and chemical resistant rubber for stations where soldering and repair take place.
• Charge decay typically 0.01 s from 5000 V to 50 V according to the series specification.
• Matte finish that keeps glare low.

Applications

Soldering and repair stations, assembly and testing of electronic assemblies, lab benches, and shelf and trolley surfaces in the EPA.

Standards

According to the manufacturer the series meets the ANSI/ESD S20.20 requirements for worksurfaces. Resistance to ground is below the 1 x 10⁹ ohm limit that IEC 61340-5-1 also sets for worksurfaces.