großer Leiterplattentisch für HR550XL - Ersa 0HR554XLL

As soon as an assembly is longer than the standard table can carry, it has to be re clamped during the process, and every re clamp costs a new reference run and risks warping at the free edge. The 0HR554XLL large board table accepts boards up to 680 x 600 mm (+x) and covers formats the standard HR 550 XL table can no longer hold at 530 x 610 mm (+x).

Benefits

• Capacity up to 680 x 600 mm (+x), one setup instead of two for backplanes and long assemblies.
• Guides the board over its full length, reducing sag above the 530 x 530 mm bottom heater.
• Matched to the HR 550 XL axis system, which approaches the component position with a resolution below 20 µm.
• Genuine Ersa accessory, fitted without frame modification and without losing system approval.

Technical data

Applications

Rework on backplanes, power assemblies and long control boards where the standard table runs out at the edge. With thin boards of this format add support rails and board clamps so the assembly stays in plane over its whole length.