Measuring Case Set Labeohm EASY with two shielded probes 63 mm - Iteco 9265057

Routine control of an EPA is usually satisfied by a reading in decades, what matters is a reproducible electrode. The Labeohm EASY case set combines the meter 9265.055 with two shielded probes 9265.065 of 63 mm diameter and 2.3 kg contact weight each.

Operating benefits

• Lower priced entry into point to point measurement, since the meter shows the decade instead of one significant digit.
• Two probes of identical design at 2.3 kg keep the contact pressure on mat and floor constant.
• Single button operation, which suits trained shop floor inspectors as well.
• Measuring range 10^4 to 10^12 ohm covers conductive, dissipative and insulating surfaces.
• Automatic test voltage, 10 V below 100 kohm and 100 V above 100 kohm.
• The case at 5.5 kg total keeps meter, probes, cords and battery together.

Typical applications

• Regular inspection round through production, store and test area with one outfit.
• Point to point measurement on floor coverings and table mats with defined contact weight.
• Determining the ground resistance of workstations through the ground cord.
• Basic equipment for the ESD coordinator of a single site.

Compatibility and scope of delivery

The concentric ring probe 63/30 mm at 2.5 kg (Iteco 9265.070), the counter-electrode 150 x 150 mm (Iteco 9265.047) and the 25 cm T-handle with M5 thread (Iteco 9265.072) fit as additions. The same case with the more accurate Labeohm EVO meter carries the number Iteco 9265.056. For test voltages up to 500 V and a memory for 100 readings the Gigalab EVO case set Iteco 9265.064 is available.

Standards and origin

The electrode arrangement of the meter follows DIN EN 100015/1, the measurements serve the monitoring of the EPA to IEC 61340-5-1. A traceable ISO 9000 calibration report is enclosed, Iteco handles recalibration under 9265.003. Made in Italy.