Surface Resistance Meter Labeohm EASY 10^4 to 10^12 Ohm, 100 V - Iteco 9265055

For the daily walk through the EPA the order of magnitude of the resistance is usually enough. That is what the Labeohm EASY is built for, it places mats, worktops and floors within 10^4 to 10^12 ohm into a decade and shows the result on an illuminated scale.

Operating benefits

• Reading on a decade scale, one press of the MEAS button is all it takes, there is no menu and no setting.
• Two embedded parallel electrodes of soft conductive rubber to DIN EN 100015/1 rest directly on the surface under test.
• Resolution of one decade, sufficient to classify a surface as conductive, dissipative or insulating.
• Automatic change of test voltage, 10 V below 100 kohm and 100 V above 100 kohm.
• LO BAT indicator prevents readings taken with an exhausted 9 V block battery.
• At 0.3 kg and 27 mm thick it suits mobile use across many test points.

Typical applications

• Quick check of table mats and floor coverings at the start of a shift.
• Control of the ground resistance of single workstations with the ground cord.
• Testing ESD containers, shelves and packaging for their resistance class.
• Equipping several inspectors while a more accurate meter stays in the laboratory.

Compatibility and scope of delivery

The shielded probe 63 mm at 2.3 kg (Iteco 9265.065) and the concentric ring probe 63/30 mm at 2.5 kg (Iteco 9265.070) can be connected, for floor work the 25 cm T-handle with M5 thread (Iteco 9265.072) is available. As a complete case set with two probes the version Iteco 9265.057 is offered. If one significant digit and a programmable alarm are required, choose the Labeohm EVO Iteco 9265.051.

Standards and origin

The electrode arrangement follows DIN EN 100015/1, the measurements serve the monitoring of the EPA to IEC 61340-5-1. A traceable ISO 9000 calibration report is enclosed, Iteco handles recalibration under 9265.003. Made in Italy.