Soldering tip conical bent 30 degrees 0.4 mm STTC series - Metcal STTC-026

When the joint sits sideways under a component, a bent tip beats a straight one. The STTC-026 is a conical soldering cartridge with 0.4 mm diameter, 7.9 mm tip length and a tip bent by 30 degrees. Heating is regulated by the Curie point of the alloy inside the cartridge body, so the 357 °C working temperature is fixed and needs no calibration.

Benefits

• Tip bent by 30 degrees for a flat approach angle and a clear view of the joint
• Tip diameter of 0.4 mm for fine pitch pins and small chip parts
• Tip length of 7.9 mm for controlled guidance at a low lever arm
• Fixed 357 °C tip temperature with no readjustment
• For the MX-500, MX-5000 and MX-5200 systems

Technical data

Applications

For joints under shielding and flat components, for microscope work with a low hand position and for rework on leads that are hard to see.

Compatibility and scope of delivery

The cartridge runs on the MX-H1-AVA and MX-RM3E hand pieces and therefore on the Metcal MX-500, MX-5000 and MX-5200 systems. It is exchanged without tools while the unit stays powered. Delivery covers one single soldering cartridge without hand piece and without power unit.