PreciForce crimping pliers for insulated and uninsulated wire end ferrules 0.25 to 6 mm², 220 mm - Knipex 97 52 38

Wire end ferrules only stay tight in terminal blocks if the crimp is complete and identical across every cross-section. The 97 52 38 PreciForce crimping pliers crimp insulated and uninsulated ferrules from 0.25 to 6.0 mm² in five locators with a factory-calibrated crimping pressure.

Benefits

• Consistently high crimping quality thanks to precision dies and a ratchet mechanism that can be unlocked when needed.
• Crimping pressure is precisely set and calibrated at the factory, so the tool does not have to be readjusted.
• Five locators cover 0.25 to 6.0 mm², matching AWG 24 to 10.
• Suitable for insulated and uninsulated wire end ferrules alike, so a second tool is not required.
• Efficient lever action delivers a high crimping force, even 6.0 mm² takes little effort.
• Good handling thanks to the short design, ergonomically shaped grips and a height of only 21 mm.

Areas of use

Control cabinet building, control system construction, electrical installation and service work. A typical job is preparing fine-stranded conductors for terminal blocks, contactors and terminal strips, where many ferrules are crimped one after another in the same quality.

Standards and conformity

The manufacturer does not state a tool standard for this product but defines the application as insulated and uninsulated wire end ferrules. According to the manufacturer the pliers contain substances of very high concern under REACH, and the RoHS directive does not apply. The crimping die is not exchangeable.