PreciForce crimping pliers for heat shrink connectors, 0.5 to 6.0 mm², 220 mm - Knipex 97 52 37

Heat shrink connectors seal a joint against moisture, but only if the metal barrel underneath is crimped properly. The PreciForce crimping pliers 97 52 37 process these connectors from 0.5 to 6.0 mm² in three dies and release the crimp through the ratchet only once the cycle is complete.

Advantages

• Consistently high crimping quality thanks to precision dies and a ratchet that can be unlocked when required.
• Crimping pressure is set and calibrated at the factory, nothing has to be adjusted on the tool.
• Three dies for the 0.5 to 6.0 mm² range, equal to AWG 20 to 10, so one tool covers the common cross-sections.
• High crimping force from the efficient lever action, the crimp is completed with one hand.
• Good handling due to the favourable handle position, short 220 mm design and a weight of only 478 g.
• Ergonomically shaped multi-component grips, the crimping die is permanently fitted and cannot go missing.

Areas of use

Vehicle and marine electrics, outdoor installations, agricultural machinery and maintenance. Wherever connections have to be protected against moisture and vibration and connectors with heat shrink insulation are therefore used.

Standards and conformity

The manufacturer does not state a tool standard for these pliers. According to the manufacturer they contain substances of very high concern under REACH, the RoHS directive is not applicable.