Electricians' pliers 5 in 1 for cutting, stripping and crimping, 0.5 to 2.5 mm2, 160 mm - Knipex 13 02 160

Cable work usually means constantly swapping between side cutter, stripper and crimping pliers. The 13 02 160 electricians' pliers cover five of those steps with a single 139 g tool and strip conductors from 0.5 to 2.5 mm2 through precision holes.

Benefits

• Suitable for cutting, bending, gripping, crimping and stripping, which removes the tool change during cabling.
• Precision stripping holes for 0.5 to 0.75 as well as 1.5 and 2.5 mm2, the insulation comes off without nicking the strands.
• Precision cutting edges additionally induction-hardened to about 60 HRC, also for medium hard and hard wire.
• Crimping section for wire ferrules, so the connection is made right at the terminal.
• Comfort handles made of three ergonomic components for optimised handling through long installation days.
• Two KNIPEXtend interfaces accept extensions, for example for drop prevention.

Areas of use

Electrical installation, control cabinet and control system building, service on wiring harnesses and anywhere on a ladder or in a duct where there is little room for several pliers. An obvious choice for the service van and the tool bag.

Standards and conformity

The manufacturer does not state a tool standard for this product. According to the manufacturer the pliers contain no substances of very high concern under REACH, the RoHS directive does not apply.