Electronics end cutting nippers with box joint, soft wire up to 1.4 mm dia., 115 mm - Knipex 64 12 115

When populating and reworking printed circuit boards, wire ends have to be cut close to the component without pulling on the solder joint. The 64 12 115 electronics end cutting nippers cut soft wire up to 1.4 mm dia. and medium hard wire up to 0.8 mm dia., in a tool only 115 mm long weighing 70 g.

Benefits

• Precision pliers for ultra fine cutting work in electronics and fine mechanics, the 11 mm head width reaches into densely packed assemblies.
• Sturdy box joint guides the cutting edges without play and keeps the cut clean over the life of the tool.
• Low friction double spring opens the pliers smoothly and evenly, which relieves the hand during long cutting sequences.
• Cutting edges additionally laser hardened to at least 56 HRC, so they stay sharp even on fine wire.
• Mirror polished head with a fine film of oil protects against rust, and no circuit faults are caused by peeling chrome from plated tools.
• End cutter with small bevel, 16 mm cutting edge length on a 12 mm jaw for almost flush cuts.

Areas of use

Electronics manufacturing and PCB assembly, fine mechanics, model making, laboratory and repair service. Wherever thin wires and component leads are shortened close to the board and a coarse diagonal cutter can no longer reach.

Standards and conformity

The pliers comply with DIN ISO 9654 for electronics pliers. According to the manufacturer they contain no substances of very high concern under REACH. The RoHS directive does not apply to this product.