Precision electronics diagonal cutter, mini head without bevel, 64 HRC, 120 mm - Knipex 79 22 120

If the component lead is to end flush with the board, the cutting edge must have no bevel. The 79 22 120 precision electronics diagonal cutter therefore cuts without a bevel and, with a mini head of only 9 mm width, still reaches between closely spaced parts, soft wire from 0.1 to 1.3 mm dia.

Benefits

• Cutting edges without bevel sever the lead flush, leaving no stub standing above the solder pad.
• Mini head with 9 mm head width and 6.5 mm jaw length reaches wires that a standard electronics cutter is too wide for.
• Very precisely ground, sharp cutting edges for exact cuts on sensitive electronic components, additionally induction hardened to approx. 64 HRC.
• Bolted joint with particularly carefully machined joint surfaces for even, low-friction movement across the whole opening range.
• Smooth-running double spring opens the pliers gently and evenly, while ergonomically optimised multi-component sleeves relieve the hand.
• Approx. 20 percent lighter than conventional electronics pliers, here 57 g at 120 mm length.

Areas of use

Board assembly and rework, precision mechanics, laboratory work, model making and prototyping. The version without bevel suits every job where leads should be cut flush and access between components is tight.

Standards and conformity

The cutter complies with DIN ISO 9654. According to the manufacturer it contains no substances of very high concern under REACH. The RoHS directive does not apply to this product.