Wire feed stopper for crimping die 97 49 28, limits the insertion depth, 30 x 10 mm - Knipex 97 49 28 1

If the wire is pushed too far into the crimp contact, the contact surface is no longer correct. The wire feed stopper 97 49 28 1 is the accessory for crimping die 97 49 28 and sets the insertion depth, so every contact is filled to the same point. The part measures 30 x 10 mm and weighs 30 g.

Benefits

• Sets the insertion depth of the wire, so the crimp joint stays identical across a whole batch.
• Matched exactly to crimping die 97 49 28, no improvising with pencil marks on the conductor.
• Part of the KNIPEX system of crimping pliers and exchangeable crimping dies.
• At 30 g and 30 x 10 mm very small, the part simply stays with the die in the case.
• According to the manufacturer free of substances of very high concern under REACH.

Areas of use

Vehicle and equipment electrics, control engineering, cable assembly and service. Wherever contacts are crimped with die 97 49 28 in larger quantities and every crimp joint has to look the same.

Standards and conformity

According to the manufacturer the product contains no substances of very high concern under the REACH regulation. The RoHS directive does not apply to this product.