Die set for Molex Micro-Fit 3.0 connectors, AWG 30 to 20, 50 x 12 mm - Knipex 97 49 25

Contacts of the Micro-Fit 3.0 series are small and the crimping zone leaves hardly any margin. The crimping die 97 49 25 covers the range AWG 30 to 20 for these contacts and is fitted into the KNIPEX crimp system pliers of the 97 43 xx range. The die measures 50 x 12 mm and weighs 41 g.

Benefits

• Matched to the contacts of the Molex Micro-Fit 3.0 series, no readjusting of the tool.
• Working range AWG 30 to 20, covering the usual conductor sizes of this connector family.
• Exchangeable: the same crimp system pliers carry on working with every die of the range.
• The additionally available locator makes it easier to guide the contacts during the crimping process.
• At 41 g and 50 x 12 mm small enough to carry several dies in the case.

Technical data

Areas of use

Electronics and equipment manufacturing, control engineering, vehicle and prototype building. Wherever Micro-Fit 3.0 contacts are assembled in series or re-crimped individually during service.

Standards and conformity

According to the manufacturer the product contains no substances of very high concern under the REACH regulation. The RoHS directive does not apply to this product.