ESD plastic tweezers straight, needle points 0.3 mm, carbon fibre reinforced, 115 mm - Knipex 92 09 02 ESD

The smallest SMD components can only be picked up if the tip is narrower than the part itself. The straight 92 09 02 ESD plastic tweezers therefore work with needle points of 0.3 mm and 0.5 mm tip width, are tested to DIN EN 61340-5-1 and weigh only 5 g at a length of 115 mm.

Benefits

• ESD tested to DIN EN 61340-5-1 and dissipative, the surface resistance between 10^2 and 10^4 ohms equalises differences in potential between operator and component in a controlled way.
• 30% carbon fibre reinforced plastic, electrically and thermally highly conductive, with high resistance to abrasion and scratching.
• Temperature stable up to 130 °C, short term use up to 190 °C is possible.
• Fully elastic, fatigue resistant, vibration damping and water repellent, with good chemical resistance to most oils, greases, fuels and non-polar solvents.
• Needle point design with 0.5 mm and 0.3 mm tip width for work in the tenth of a millimetre range.
• Straight design for direct access to magazines, tape sections and test fixtures, 115 mm long at 5 g.

Areas of use

Work with maximum surface protection on sensitive electronic components, on micro-mechanical parts and on glass and ceramic components, at EPA workstations in production, laboratory and service. According to the manufacturer the model is also available in the 92 00 05 ESD set.

Standards and conformity

The manufacturer states DIN EN 61340-5-1 for this tool. The tweezers are ESD tested and dissipative, there is no VDE test. According to the manufacturer they contain no substances of very high concern under REACH and the RoHS directive does not apply.