Precision electronics diagonal cutter, pointed head, small bevel, 64 HRC, 125 mm - Knipex 79 32 125

Between connectors, heat sinks and upright components, only a slim tapering plier reaches the wire. The 79 32 125 precision electronics diagonal cutter therefore has a pointed head of 11 mm width and cutting edges of approx. 64 HRC that cut soft wire from 0.2 to 1.5 mm dia. cleanly.

Benefits

• Pointed head with 11 mm head width and 11 mm jaw length reaches densely populated component areas without touching neighbouring parts.
• Very precisely ground, sharp cutting edges for exact cuts on sensitive electronic components, hard wire up to 0.6 mm dia.
• Cutting edges additionally induction hardened, cutting edge hardness approx. 64 HRC, with a very small bevel for cuts close to the board.
• Bolted joint with particularly carefully machined joint surfaces for even, low-friction movement across the whole opening range.
• Smooth-running double spring opens the pliers gently and evenly, while ergonomically optimised multi-component sleeves relieve the hand.
• Approx. 20 percent lighter than conventional electronics pliers, here 58 g at 125 mm length.

Areas of use

Board assembly, repair and rework, precision mechanics, laboratory work, model making and prototyping. The pointed head suits every job where access to the wire between components and connectors is tight.

Standards and conformity

The cutter complies with DIN ISO 9654. According to the manufacturer it contains no substances of very high concern under REACH. The RoHS directive does not apply to this product.