Precision electronics diagonal cutter pointed without bevel, edges 64 HRC, 125 mm - Knipex 79 42 125

Anyone cutting component leads on densely populated boards needs a head that fits between the parts. The 79 42 125 precision electronics diagonal cutter has a pointed head only 11 mm wide, works without a bevel and cuts soft wire from 0.1 to 1.5 mm dia. with induction hardened edges of approx. 64 HRC.

Benefits

• Very accurately ground, sharp cutting edges for exact cuts on sensitive electronic components.
• Edges additionally induction hardened, cutting edge hardness approx. 64 HRC, medium hard wire up to 0.8 mm dia.
• Approx. 20 % lighter than conventional electronics pliers, here 58 g at 125 mm length.
• Bolted joint with particularly carefully machined joint faces for an even, low-friction movement over the whole opening range.
• Smooth-running double spring for gentle and even opening, plus ergonomically optimised multi-component sleeves.
• Pointed head without bevel, jaw length 11 mm, for access to tightly packed component areas.

Areas of use

The finest cutting work in electronics and precision mechanics, board assembly and repair, laboratory work and prototyping. The pointed head without bevel suits every job where access between components is tight and the lead should end flush.

Standards and conformity

The cutter complies with DIN ISO 9654. According to the manufacturer it contains no substances of very high concern under REACH. The RoHS directive does not apply to this product.