RS 180 Double-Groove Divider Wall 300 with Base Stop, Reinforced, 255 x 22 x 345 mm

In the RS 180 rack system the grooved wall does the guiding. This version is the reinforced one and carries the type 022 base stop, so inserted assemblies rest on a defined stop instead of sliding down out of the groove.

Benefits

• Reinforced version of the double-groove wall 300, intended for racks that stay loaded while being moved.
• Type 022 base stop as the lower limit, boards sit at one common height and cannot drop through.
• Outer size 255 x 22 x 345 mm, the wall stays slim and leaves room for further walls in the rack.
• Guided in grooves rather than stacked, component side and solder side never touch.
• Own weight 0.93 kg, a loaded magazine can still be moved by hand.
• Part of the ESD storage programme around the RS 180 rack system and its board holders.

Application

The wall is used in board processing and handling, as a buffer between assembly and test station, for in-house transport of populated boards and for interim storage inside the ESD protected area.

Note on the range

The double-groove wall 300 with base stop exists in a reinforced and an unreinforced variant. This listing covers the reinforced one.