Manual press for Ø 10 mm snap fasteners and eyelets without tooling - Iteco 7804811

Anyone cutting ESD matting to size or replacing damaged ground points needs a properly set snap fastener rather than an improvised joint. The Iteco 7804.811 manual press sets Ø 10 mm snap fasteners and eyelets through a lever and, at 3.3 kg, stays steady while pressing.

Benefits

• Sets Ø 10 mm snap fasteners and eyelets of the type used for ground points on ESD table and floor mats.
• A compact footprint of 80 x 180 mm with 280 mm height fits on any converting bench.
• The base plate carries mounting holes so the press can be bolted down.
• The lever works purely mechanically, neither compressed air nor power is required.
• Punch and anvil are deliberately not included, so only the tooling actually needed has to be purchased.

Applications

Cutting ESD table mats to size, retrofitting and replacing ground points in floor coverings and repairing damaged snap fasteners on existing matting.

Standards and origin

The ground points created serve the bonding of worksurfaces and floors as required by IEC 61340-5-1. Made in Italy.