Surface Resistance Meter Labeohm EVO 10^4 to 10^12 Ohm, 100 V - Iteco 9265051

Anyone running an EPA has to re-measure mats, worktops and floors at regular intervals. The Labeohm EVO covers 10^4 to 10^12 ohm and shows the reading on a graphic LCD with an accuracy of half a decade.

Operating benefits

• Two embedded parallel electrodes of soft conductive rubber to DIN EN 100015/1 allow surface resistance measurement without additional parts.
• Accuracy of half a decade with one significant digit instead of a plain order of magnitude.
• Graphic LCD with 102 x 64 pixels on 36 x 26 mm stays readable at an angle.
• Acoustic alarm with programmable threshold reports limit violations without the operator watching the display.
• Test voltage is selected automatically, 10 V below 100 kohm and 100 V above 100 kohm.
• Housing of 120 x 80 x 27 mm at 0.3 kg fits into a coat pocket and travels along the production walk.

Typical applications

• Incoming inspection and periodic control of ESD table mats and floor coverings.
• Checking the ground resistance of workstations through the supplied ground cord.
• Point to point measurement on racks, containers and trolleys with two external probes.
• Documented audit walks within the ESD control programme to IEC 61340-5-1.

Compatibility and scope of delivery

Two external probes can be connected for measurements with a defined electrode load, the shielded probe 63 mm at 2.3 kg (Iteco 9265.065) and the concentric ring probe 63/30 mm at 2.5 kg (Iteco 9265.070). For repetitive floor measurements there is the T-handle with M5 thread and 25 cm length (Iteco 9265.072). If you need everything together, order the case set Iteco 9265.056.

Standards and origin

The meter supports verification within the ESD control programme to IEC 61340-5-1. The electrode arrangement follows DIN EN 100015/1. A traceable ISO 9000 calibration report is included, recalibration is available as Iteco 9265.003. Made in Italy.