Electric screwdriver 230 V push start 0.4 - 3.0 Nm, 650 rpm, bit grounding - Delvo DLV30A06P-ABK

With push to start, pressure on the screw is enough to run the tool, which then shuts off at the preset value. Between 0.4 and 3.0 Nm the result stays the same over long runs and no hand is tied up triggering the tool.

Benefits

• Push to start, the tool runs as soon as it is set on the screw, which saves a movement on every screw and keeps the cycle steady.
• Direct connection to 230 V AC, no control unit or power supply is needed at the bench.
• Two torque springs cover the range, the soft one from 0.4 to 1.6 Nm is supplied with the tool and the hard one from 1.2 to 3.0 Nm is fitted.
• Torque is set steplessly on the adjustment ring, and the cover over it keeps the set value from being changed by accident.
• Bit grounding is fitted as standard, so charge is led away through the tool instead of through the assembly. At ESD protected workstations nothing has to be retrofitted.
• Rated for cyclic work with 0.5 s on and 3.5 s off, which matches the rhythm of a manual assembly station. 3 m cord, 700 g at around 45 W, brushless motor with shut-off clutch and a design that conforms to the RoHS Directive.

Applications

Series assembly of small units, electronics and device manufacturing, housing and sheet metal joints at manual workstations with ESD protection.

Matching accessories

Bits with a 4 mm shank are taken by the ADA-HR4-D63 adapter. The BAL-0515 and BAL-1020 tool balancers carry the tool weight, and the SGR-14 and SGR-23 screw grids keep the screws ready at the bench.