Phillips screwdriver bit PH2, 4 mm blade dia., 44 mm long, 4 mm shank - Delvo DLB2130

In device assembly the bit decides whether the torque set on the screwdriver reaches the screw head. This Phillips bit PH2 with a 4 mm blade seats in the drive of Delvo electric screwdrivers through its 4 mm half-round shank, with nothing in between.

Benefits

• Fits straight into any Delvo screwdriver with a 4 mm half-round drive, so no extra play enters the drive train.
• Blade diameter of 4 mm, the size the NK4D range assigns to Phillips No. 2, with an 11 mm blade length for recessed heads.
• Overall length of 44 mm, 3.5 mm shank diameter at the transition and a collar at 20 mm for a defined seating position.
• Hardness grade H, the hardest grade in the range, rated by the manufacturer for screw sizes from 1 to 3 mm.
• Special alloy that Nitto Kohki prepares for screwdriver bits alone, heat treated and hardness tested in house, with minimal runout.

Applications

Electronics assembly, control cabinet building, precision engineering and repair benches where Phillips No. 2 screws are tightened repeatably with a Delvo electric screwdriver.

Matching accessories

Fits the Delvo electric screwdrivers DLV-7410-BME6, DLV-7420A BME6 and DLV-7331-BME6. On screwdrivers with a 1/4 inch drive it runs through the ADA-HR4-D63 adapter. The MAG-RING-4,7 and MAG-RING-6,0 ring magnets hold the screw on the bit. The same range also covers DLB2126 for Phillips No. 1 and DLB2131 with an overall length of 64 mm.