Emit Chargebuster Overhead Ionizer, 3 Fans, 220 V AC, No Power Cord - Desco 50681

When insulators and isolated conductors have to stay in the process, ionization is the only way to remove their charge. The Emit Chargebuster mounts above the workstation and keeps the bench clear. Three shrouded fans cover about 61 x 152 cm and discharge in less than 3 seconds with an offset voltage of ± 10 V.

Key benefits

• Discharge time under 3 s at 46 cm and ± 10 V balance, well inside the ± 35 V limit of ANSI/ESD S20.20
• Pure tungsten emitters spaced further apart reduce recombination and widen the coverage area
• Auto-feedback system with audible alarm and tri-color LED, the unit shuts down if supply voltage drops
• 3 fan speeds (low, medium, high) with consistent ionization performance, suitable for calibration and test stations
• Field-replaceable emitter pins keep downtime short
• Low ozone emission, well below the OSHA limit of 0.05 ppm

Applications

Electronics manufacturing, assembly, calibration, test and repair stations inside the EPA. Hang the ionizer from the supplied kit or screw its brackets to a shelf. Keep the fan intake grills clear.

Standards

Discharge time and offset voltage meet ANSI/ESD S20.20, tested per ANSI/ESD STM3.1 and ESD TR53. Ionization supplements grounding but does not replace it. Clean the emitters regularly and verify performance with a charged plate monitor.